DUPLO SEIKO CORPORATION Duprinter DP-330, Руководство по обслуживанию

Страница: 167 / 330

166
c
Paper Feed Section
chap.4
(4) Adjusting the Elevator Lower Limit Switch
¡
For description of operation.
¡
For removal.
Adjustment method
1) Access HELP mode H-02.
For the accessing HELP modes:
2) Press and hold down the "CURSOR" PRINT-
ING SPEED ADJUSTMENT key until the paper
feed tray is at its lower position. The elevator
motor will run (i.e. the paper feed tray will
descend) for as long as the key is held down.
3) Check that the dimension indicated in the figure
at right conforms to the value shown below.
\
See page 219
HELP mode H-02
\
see p.227
\
See page 132
\
See page 76
NOTE :
If the feed length is not the standard value
1) Loosen the screws, then adjust the lower limit
switch to a position that yields the standard
clearance value.
c
Moving the sensor in the direction shifts the
lower position downward.
d
Moving the sensor in the direction shifts the
lower position upward.
2) After adjustment, tighten the screws.
Standard value
Standard value Item
Paper feed tray clearance in
lower limit position
5mm
440161
440120
5mm
Elevator lower limit switch
Screw