Dell Qlogic QME8242, Руководство пользователя

Страница: 137 / 178

4–Boot Configuration
iSCSI Configuration Using Fast!UTIL
CU0354602-00 A 4-11
iSCSI boot setup information includes the following:
 Boot Device Primary and Alternate
 Adapter Boot Mode
 Primary and Alternate Boot Device Settings
 Configuring the iSCSI Boot Parameters
 Configuring the iSCSI Boot Settings
 Preparing the Image on the Local Hard Drive
 Transferring the OS Image to the iSCSI Target
 Booting
Boot Device Primary and Alternate
After configuring a device (through Primary/Alternate Boot Device Settings ),
press ENTER on these locations to view a list of available devices. To select an
iSCSI boot device, highlight the device, and then press ENTER.
Adapter Boot Mode
 Disable —Select this option to disable the ROM BIOS on the QME8242
adapter, freeing space in upper memory.
 Manual —Select this option to manually configure the parameters for the
iSCSI boot device in the Primary/Alternate Boot Device Settings area.
Manual parameters include the following:
 Initiator IPv4/IPv6 Address via DHCP —When set to Yes , the
QME8242 adapter uses DHCP to obtain its IP address, subnet mask,
and gateway IP address. Press ESC three times to save the changes.
These values are not populated when you save the settings for the IP
address, subnet mask, gateway, IPv6 routable addresses, and initiator
IPv4 or IPv6 address. When DHCP is set to
No , this field must contain
a valid IP address.
 Subnet Mask —When DHCP is set to No , this field must contain a valid
subnet mask.
 Gateway IP Address —When DHCP is set to No , this field must contain
a valid gateway IP address.
 Initiator iSCSI Name —Press ENTER to configure the iSCSI name of
the initiator. By default, the iSCSI name (containing two parts, the
standard product model and serial number) is used. If you change the
iSCSI name, you need to flash the adapter to make the name change
permanent.
 Initiator CHAP Name —Press ENTER to configure the bidirectional
CHAP name.