Dell Qlogic QME8242, Руководство пользователя, Страница: 77 / 178

3–Adapter Management Applications
General Management with QConvergeConsole
CU0354602-00 A 3-17
4. On the Converged Network Adapter (CNA) Protocol Type Selection menu,
select
1, CNA iSCSI Configuration .
5. On the Converged Network Adapter (CNA) iSCSI Configuration menu,
select
3, Port IP Settings .
6. Select the Converged Network Port you want to configure.
7. Select 2, Configure IP Settings .
8. Complete the interactive list of settings as follows:
a. Enable IPv4 [on]: Press ENTER to accept the default.
b. DHCP to obtain IPv4 Network Information: [off]: Press ENTER to
accept the default.
c. IP_Address [ ]: Type the IP address of the initiator system, and then
press ENTER.
d. IP_Subnet_Mask [255.255.255.0]: Type the appropriate subnet mask,
and then press ENTER.
e. IP_Gateway [0.0.0.0]: Press ENTER to accept the default.
f. Enable IPv6 [off]: Press ENTER to accept the default.
9. On the options menu that appears, select 3, Save changes and reset HBA
(if necessary) .
10. At the prompt for both ports, type
Yes
.
11. To return to the Converged Network Adapter (CNA) iSCSI Configuration
menu, type P and press ENTER, and then type P and press ENTER again.
12. On the Converged Network Adapter (CNA) iSCSI Configuration menu,
select 4, Target Configuration .
13. Select the same Converged Network Port you selected in Step 6 .
14. Select 6, Add a Target .
15. Complete the interactive list of settings as follows:
a. IPv6 Target? [off]: Press ENTER to accept the default.
b. TGT_iSCSI_Name [ ]: Type the iSCSI Qualified Name (IQN) of the
iSCSI target to connect to, and then press ENTER.
c. TGT_Port [3260]: Press ENTER to accept the default.
d. TGT_TargetIPAddress [0.0.0.0]: Type the IP address of the target, and
then press ENTER.
16. On the options menu that appears, select 12, Save Target/CHAP Changes .
The iSCSI initiator is now configured to connect to the iSCSI target.