Dell Qlogic QME8242, Руководство пользователя, Страница: 146 / 178

4–Boot Configuration
iBFT Boot Setup (iSCSI)
4-20 CU0354602-00 A
Setting Up iBFT on IPv4
You can set up iBFT on IPv4 with either a static IP address (see “Setting Up a
Static IPv4 Address” on page 4-20 ) or a dynamic IP address (see “Setting Up a
Dynamic IPv4 Address” on page 4-22 ).
Setting Up a Static IPv4 Address
To set up a static IP address on IPv4, follow these steps:
1. Start the server and when the NIC boot code banner appears, press CTRL+Q.
The QLogic CNA Function Configuration utility opens to the Select Adapter
menu.
2. Select the adapter to configure, and then press ENTER.
The QLogic CNA Function Configuration utility opens to the Setup menu for
the selected adapter.
3. Under Function Configuration, select the iBFT function to configure, and
then press ENTER.
4. Under Adapter Settings, configure the following, as shown in Figure 4-11 :
a. Set Enable ROM to Enabled .
b. Set IP Format to IPv4 .
c. Set the VLAN Mode to one of the following:
 Disabled if the VLAN is not used in the network
 Enabled to specify a valid VLAN ID
d. If VLAN is enabled, specify a valid VLAN ID in the range of 2 to 4095.
Figure 4-11. Configuring Adapter Settings for IPv4 (Static)