Dell Qlogic QME8242, Руководство пользователя, Страница: 79 / 178

3–Adapter Management Applications
General Management with QConvergeConsole
CU0354602-00 A 3-19
15. Complete the interactive list of settings as follows:
a. IPv6 Target? [off]: Press ENTER to accept the default.
b. TGT_iSCSI_Name [ ]: Type the iSCSI Qualified Name (IQN) of the
iSCSI target to connect to, and then press ENTER.
c. TGT_Port [3260]: Press ENTER to accept the default.
d. TGT_TargetIPAddress [0.0.0.0]: Type the IP address of the target, and
then press ENTER.
16. On the options menu that appears, select 12, Save Target/CHAP Changes .
The iSCSI initiator is now configured to connect to the iSCSI target.
Configuring the ESX iSCSI Initiator
The software iSCSI initiator must be enabled for ESX/ESXi to be able to use it for
accessing iSCSI storage.
To configure an ESX/ESXi initiator:
1. Log in to the vSphere Client.
2. In the inventory panel, select a server to which to connect.
3. Click the Configuration tab.
4. In the Hardware panel, click Storage Adapters .
5. From the list of available storage adapters, select the iSCSI initiator you
want to configure, and then click
Properties .
6. Click Configure .
The General Properties dialog box shows the initiator’s status, default
name, and alias.
7. To enable the initiator, click Enabled .
8. (Optional) To change the default iSCSI name for your initiator, type a new
name. The name you enter must be worldwide unique and properly
formatted so that all storage devices can recognize the software iSCSI
initiator.
9. To save your changes, click OK .
NOTE:
If you change the iSCSI name, it is used for new iSCSI sessions.
Existing sessions do not use new settings until you log out and log in
again.