Dell Qlogic QME8242, Руководство пользователя

Страница: 28 / 178

2–Driver Installation and Configuration
Windows Driver Installation and Configuration
2-10 CU0354602-00 A
Windows Server 2003
This procedure requires a system with a floppy drive. Before you begin, extract
the drivers from the SuperInstaller (see
“Extracting and Installing Windows Drivers
Manually” on page 2-2 ).
To initially install Windows on the boot from SAN disk attached to the QLogic
FCoE Converged Network Adapter:
1. Start the Windows installation procedure using the setup CD.
2. Press F6 when the following message appears:
Press F6 if you want to install a third-party SCSI or RAID driver....
After all the standard devices have been loaded, press S to Specify
Additional Device.
3. Insert the QLogic driver diskette and press ENTER.
4. Select the QLogic FCoE Adapter and press ENTER.
5. For Windows Server 2003, press S to use the driver on the floppy drive.
6. The following message appears:
Setup will load support for the following mass storage devices.
QLogic FCoE Adapter.
Press Enter=Continue.
7. Press ENTER.
8. Continue with the standard installation procedure.
Windows Server 2008
This procedure requires a USB flash drive. To initially install Windows on the boot
from SAN disk attached to the QLogic Fibre Channel Adapter, follow these steps:
1. Start the Windows installation procedure using the setup CD.
2. When the following message appears, click Custom (Advanced) :
Which type of installation do you want?
3. When the following message appears, click Load Driver :
Where do you want to install Windows?
NOTE:
You must apply the Microsoft Storport update before installing or upgrading
the driver. Windows Server 2003 SP2 (or later) requires Microsoft fixes
KB932755 and KB939315 (or later). Windows Server 2003 SP1 requires
Microsoft fixes KB932755 and KB939315 (or later). For Boot from SAN
installation, use the Windows 2003 SP2 first, and then apply the KB update.