Dell Qlogic QME8242, Руководство пользователя

Страница: 147 / 178

4–Boot Configuration
iBFT Boot Setup (iSCSI)
CU0354602-00 A 4-21
5. Under Adapter Settings, select Initiator Settings, and then press ENTER.
6. Under Initiator Settings, configure the following, as shown in Figure 4-12 :
a. Set Enable DHC P to Disabled ; the Target Param From DHCP is
automatically set to Disabled .
b. The Initiator Name is set automatically; set the Initiator IP Address ,
Initiator Subnet Mask , and Gateway according to the network setup.
c. (Optional) Configure the Reverse CHAP Name and Reverse CHAP
Secret as needed.
d. Press ENTER to save these settings.
Figure 4-12. Configuring Initiator Settings for IPv4 (Static)
7. Press ESC to return to the Adapter Settings menu.
8. On the Adapter Settings menu, select Primary Target Setting s, and then
press ENTER.
9. Under Target Settings , configure the following, as shown in Figure 4-13 :
a. Set the Target Nam e, Target IP Address , Target Port , and Boot LUN
to the appropriate settings for the target setup.
b. (Optional) Specify the CHAP Type as one of the following:
 None to disable CHAP
 One-Way for a target-authenticating initiator
 Mutual to enable both the target and initiator to authenticate
each other
c. (Optional) Configure the Target CHAP Name and Target CHAP
Secret as needed.