Compaq ES40CSLP, Инструкция по установке, использованию и обслуживанию

Страница: 23 / 196

Installation
Compaq ES40CSLP Rackmount System Installation/User/Service Guide 2–3
2.3 Unpacking the Shipment
TheES40CSLP rackmount system shipment may include several cartons. Check the packing list
to ensure that all items listed have been received.
If the equipment is damaged or if any items are missing, notify the delivery agent and contact
the Compaq sales representative.
Save all shipping cartons in case the equipment needs to be moved to a new location, or needs
to be returned for repair.
___________________________ WARNING _________________________
The ES40CSLP rackmount system can weigh up to 40.82 kg (90 lb). Use
sufficient personnel or the proper lifting equipment when lifting or moving the
system.
______________________________________________________________
___________________________ ACHTUNG _________________________
Das ES40CSLP Rackmount System kann bis zu 40,82 kg (90 lb) wiegen. Beim
Hochheben oder Transport des Systems sollten deshalb genügend Hilfskräfte
vorhanden sein oder die richtigen Hebewerkzeuge benutzt werden.
______________________________________________________________
2.4 Installing the ES40CSLP Rackmount System
The following sections contain the procedures for installing the ES40CSLP rackmount system
in a 48.26-cm (19-in.) EIA cabinet.
Tools Required
•
No. 1 and no. 2 Phillips-head screwdriver
•
No. 1 short (stubby) Phillips-head screwdriver
•
Flat-blade screwdriver
•
Adjustable wrench
2.4.1 Determining the Installation Area
The ES40CSLP rackmount system requires 22.23 cm (8.75 in.) of vertical space or 15
contiguous holes in a 48.26-cm (19-in.) EIA cabinet.
The holes in an EIA cabinet rail follow a pattern of 1.27 cm (0.50 in.), 1.59 cm (0.625 in.), and
1.59 cm (0.625 in.). This pattern is called a set and is repeated for the length of the cabinet rails.
To determine the installation area, perform the following steps at the front and the rear cabinet
rails (refer to Figure 2-1).
1. Select a section of the cabinet rail where there is a 1.27 cm (0.50 in.) space between two
holes and make a mark between these two holes. This is the starting point of the
installation area.
2. Count up or down 15 holes from the starting point and make a mark above or below the
15th hole. The area between these two marks is the installation area. The bottom hole
within the installation area is identified as hole 1 of the installation area.