Compaq ES40CSLP, Инструкция по установке, использованию и обслуживанию

Страница: 88 / 196

Remote System Management
4–8 Compaq ES40CSLP Rackmount System Installation/User/Service Guide
4.7.1 Defining the COM1 Data Flow
Use the set com1_mode command from SRM or RMC to define the COM1 data flow paths.
You can set com1_mode to one of the following values:
through All data passes through RMC and is filtered for the escape sequence. This
is the default.
snoop Data partially bypasses RMC, but RMC taps into the data lines and listens
passively for the escape sequence.
soft_bypass Data bypasses RMC, but RMC switches automatically into snoop mode if
loss of carrier occurs.
firm_bypass Data bypasses RMC. RMC remote management features are disabled.
local Changes the focus of the COM1 traffic to the local MMJ port if RMC is
currently in one of the bypass modes or is in through mode with an active
remote session.
Example
RMC> set com1_mode
Com1_mode (THROUGH, SNOOP, SOFT_BYPASS, FIRM_BYPASS, LOCAL): local
For more details, see the Compaq AlphaServer ES40 User Interface Guide.
4.7.2 Displaying the System Status
The RMC status command displays the current RMC settings. Table 4-1 explains the status
fields.
RMC>status
PLATFORM STATUS
On-Chip Firmware Revision: V1.0
Flash Firmware Revision: V1.2
Server Power: ON
System Halt: Deasserted
RMC Power Control: ON
Escape Sequence: ^[^[RMC
Remote Access: Enabled
Modem Password: set
Alert Enable: Disabled
Alert Pending: YES
Init String: AT&F0E0V0X0S0=2
Dial String: ATXDT9, 15085553333
Alert String: ,,,,,,5085553332#;
Com1_mode: THROUGH
Last Alert:
Logout Timer: 20 minutes
User String: