Compaq ES40CSLP, Инструкция по установке, использованию и обслуживанию

Страница: 44 / 196

Installation
2–24 Compaq ES40CSLP Rackmount System Installation/User/Service Guide
2.15 Installing an Optional Hard Disk Drive
The ES40CSLP rackmount system can contain two hard disk drives.
Perform the following procedure to install an optional hard disk drive:
1. Perform an orderly shutdown of the operating system.
2. Ensure that the power On/Off button on the OCP is in the Off position.
3. Extend the chassis for service (see Section 5.2).
4. Remove the hard disk drive cover (see Section 2.14).
5. Insert four rubber grommets
™ in the four slots on the sides (two on each side) of the hard
disk drive bracket
š.
6. Secure the hard disk drive
› to the hard disk drive bracket with four screws œ through the
four rubber grommets (see Figure 2-20).
7. Attach two rubber grommets
 to the lower sides (one on each side) of the hard disk drive
with two screws
ž (see Figure 2-20).
8. Slide the hard disk drive and bracket into one of the two available positions and apply
pressure until the two rubber grommets, on the lower sides of the hard disk drive, slide into
the grommet holders at the bottom of the position.
9. Secure the hard disk drive and bracket into position with the two captive screws
Ÿ on the
top of the hard disk drive bracket (see Figure 2-20).
10. Connect the data
and power ¡ cables to the connectors on the top of the hard disk drive
(see Figure 2-20).
After installing the hard disk drive, reverse steps 1 through 4 and reboot the system.