1. Upon completing installation of all
cabinets, drawers, doors and fixed and
adjustable shelving, fasten your counter
(1) on top of any base cabinets. (See
Fig. 1.)
2. Counter length may be trimmed to fit
with a circular or stationary crosscut
saw. (Trim the board from the appro-
priate facing side to ensure no visible
edges are ragged from the saw blade.
File or sand the cut if necessary.)
1.
For installation of multiple, contiguous slotwall panels (2) one above another, begin
installation with the bottom panel flush to the surface of the installed counter top. First,
trim and level the panel. (See step 2 above for trimming instructions.) If slotwall plastic
side caps are to be utilized in the design, be sure to accommodate trim length for
thickness of side cap(s).
2.
Mark all wall stud locations in line with slotwall installation. Mark aligned stud locations
on the slotwall panel’s top and bottom slots. Pre-drill the 4.5 x 60mm screw locations as
marked. Align drilled holes with studs for installation.
SLOTW
ALL
DESCRIPTION
Counter(s)
Slotwall(s)
#8 x 1 ” Wood screws
COUNTER
TOP
4.5 x 60mm Screws (#2309)
Slotwall Side Cap (#2554 or #2555)
3. Minor scribing may be necessary along the
back edge of the counter if the sheetrock is
substantially bowed or warped. However,
if slotwall is also being installed above the
counter, any gaps may be hidden by mount-
ing the slotwall flush to the counter surface.
4. Extra edgebanding material has been
included with each counter in the event
your counter requires trimming. Apply
replacement edgebanding to exposed edge
along visible counter lip after completing all
trimming and refitting of the counter.
Fig. 1
5. Fasten the counter top to the base cabinets in each corner from underneath using #8 x 1-1/4”
wood screws (3). If necessary, pre-drill each screw hole from the inside of each base cabinet.
(See Fig. 1.)
P
AR
TS
Counter & Slotwall
MULTI-SUITE SYSTEM ASSEMBLY
ASSSEMBL
Y ORDER
£
Hanging Cabinet
£
Drawer Assembly
£
Door Installation
¢
Counters & Slat
Wall
77
