3.
Make any necessary leveling adjustments to
doors and hinges using screws. (See Fig. 4.)
Add two bumpers per door to corners.
NOTE: Door faces may be adjusted up and down by
loosening the hinge plate’s fixing screws and sliding the
door up and down then tightening the fixing screws again.
The width of the gap between the doors may be adjusted
by tightening or loosening the adjustment screw on the
front of the hinge arm. (See Fig. 4.)
HANDLE INSTALLATION
Door handle holes are not pre-drilled. All three
available door handles are based upon 96 mm
center-to-center designs, and a hole pattern
template is available for order from ClosetMaid.
(Contact customer service.) Recommended
handle placement varies between different door
profile styles. (See Fig. 5.)
4.
It is recommended to drill handle locations
AFTER doors have been installed on cabinet
frames and NOT prior to hinge installation.
5.
Mark location of handle holes using Fig.
5’s measurements as a guide along with the
handle template. Drill marked locations.
6.
Attach the handles to the doors through the
pre-drilled holes using the #8 x 1-1/4 “ screws
enclosed.
Fig. 4
Fig. 5
Door - 2
MULTI-SUITE SYSTEM ASSEMBLY
76
