INST
ALLA
TION
Island - 2
ACCESSORY ASSEMBLY
64
a
b
c
a
c
b
Fig. 1
Fig. 2
1.
With both side panels positioned
with holes facing up, thread eight
(8) screw-in studs into the pre-
drilled holes across the top and
bottom of each panel as shown.
(See Fig. 1a.)
NOTE: Thread all screw-in studs into
holes until the stop ring is snug with the
partition face.
Thread three (3) screw-in studs into
each panel down along the three
middle holes as shown. (See Fig.
1b.)
Thread four (4) screw-in studs into each
side panel at toe kick location holes. (See
Fig. 1c.)
For optional drawer(s) assembly:
Fasten
drawer runners (using 2 Euro screws each
- provided with the drawer assembly) to
any remaining pre-drilled holes on both
side panels.
2. Place divider on side panel (along center
screw-in studs) and push cam locks over
screw-in studs. (See Fig. 2.) Use a
Phillips screwdriver to tighten all cam
locks at stud location. (See Fig. 3.)
3.
Stand side panel/divider assembly upright.
Bring other side panel in so that screw-in
studs on side panel fit into cam locks on
divider. (See Fig. 4.) Use a Phillips
screwdriver to tighten cams.
Fig. 3
Fig. 4
