bottom fixed cam shelves between vertical
panels. (See Fig. 9.) Tighten each cam lock
over a stud head one-half turn clockwise with
a Phillips head screwdriver to secure.
NOTE: If installing drawers, substitute 5/8” fixed cam shelf
from drawer pack set for standard 1” fixed cam shelf at
bottom of vertical panels.
12.
Complete feet flange fastening of remaining
Fig. 9
two screws per flange into fixed bottom
shelves. Insert and screw in all system feet
into the flanges. Adjust feet for floor leveling,
fitting tightly between floor and vertical panel.
13.
Seat and fasten remaining fixed cam shelves
throughout design.
14.
Level section panels using a 4’ level.
(Corner walls may not be level in comparison
to panels along the open wall.) Adjust plumb
of each panel using the set screw on the
bottom of each suspension bracket as needed.
(See Fig. 10.) Adjust the distance of the panels
from the wall by tightening or loosening the
distance screws. (This step ensures panel front
edges are flush for meeting doors and drawers.)
15.
Start on one wall at a corner, if design
installation is flush to corner. Then, level and
plumb each panel next to your position,
working either left or right along the wall to
the end of the system.
16.
Secure full length vertical panels (tall cabinets)
by fastening an angle (corner) bracket to each
panel using #8 x 1-1/4” through the bracket
into an Easy Anchor in the wall (or, without
Easy Anchor into a stud.) Then, fasten a #8 x
5/8” screw from through the bracket into the
panel. Angle brackets may be installed hori-
zontally on the inside of a tall cabinet for ease
of installation.
17.
Install adjustable shelving, drawers and doors.
Fig. 10
Hanging Cabinets- 4
MULTI-SUITE SYSTEM ASSEMBLY
71
