3.
Position a right hand shelf and pole bracket
in line with the level on the right return wall.
Position the torpedo level on top of the
bracket, and level the bracket to both the
back of the tower and to the front of the
torpedo level. Mark the position of the holes
to install Easy Anchors (or other appropriate
wall fasteners). (See Fig. 4.)
4.
Set down the levels and bracket and install
the Easy Anchors in the marked locations.
5.
Fasten the bracket to the Easy Anchors using
#8 x 1-1/4” screws through the bracket’s two
mounting holes.
6.
For installation of an independent pole cup
in the lower half of a double hang section on
this wall, measure down from the top of the
bracket to mark the two holes for the pole
cup. (See Fig. 5.)
7.
Set down the pole cup, and screw in two (2)
Easy Anchors in the marked locations for the
pole cup. Fasten the pole cup to the wall into
the Easy Anchors using two (2) #8 x 1-1/4”
screws.
NOTES: If you are installing pole cups or the shelf and
pole bracket to a partition, use Euro screws to fasten them
to the partition.
Top shelf and pole brackets are not intended for use with
a side wall partition, they are designed specifically for use
against drywall or other wall surface. Use independent
pole cups against side wall partitions.
If no pole will be installed to the side wall and the top
shelf and pole bracket is needed only to support the top
shelf, the pole cup support section of the bracket can be
broken away for a smooth bracket design.
Installing Continuous Top Shelf
1.
After installing the shelf/pole brackets and
independent pole cups, determine the size of
your top shelf. Measure along the back wall,
corner to corner.
NOTE: Many side walls will not be square to the back
wall and/or the corners often are slightly built up with
additional joint compound from the original wall installa-
tion. Always measure both along the back wall and in front
of the towers to determine if your top shelf trimming may
need to be slightly out of square to provide a snug fit. If the
measurements are different (not square) then you will need
to mark cut lines on both the front and back edge to match
the measurements accordingly.
Fig. 4
Fig. 5
Top Shelf & Pole - 2
SHELVING/TOWER ASSEMBLY
45
