• These instructions are for use with tall,
base or upper MultiSuite cabinets. All
cabinets must be fully assembled,
leveled and installed in their final
locations before installing the cabinet
doors. All cabinet doors have pre-drilled
hinge holes, but handle holes are not
pre-drilled.
PREP
ARA
TION
INST
ALLA
TION
1.
Position the door against the panel,
leveling the top edge of the door flush
with the top of the panel. Holding the
door open, screw the attached
mounting plates into the side panel’s
system holes, using the pre-attached
plate screws.
PAR
TS
DESCRIPTION
Door(s)
Handle(s)
Machine Screws
Mounting Plates
Hinges
#6167 Hinge Sleeves and Bolts
(for mounting doors on either side of a shared panel)
• All doors must be installed with a fixed shelf
at both the top and bottom of the door.
•
Snap each hinge into one of the sets of three
holes on the back of the door. (See Fig. 1.) To
secure the hinge to the door, turn the fastening
screw one quarter turn in the direction shown
on the hinge.
Fig. 1 Fig. 2
•
Snap the hinge mounting plates to the ends
of each attached hinge. (See Fig. 2.)
2.
For installation of hinges on shared panels and
system holes (back to back - see front view in
Fig. 3), you must remove the mounting plate’s
two fastening screws and replace them with
#56514 Hole Sleeves and Mounting Bolts
(from each side), tightening the bolts from
each side of the same panel, same hole into
the sleeve.
Fig. 3
Door
MULTI-SUITE SYSTEM ASSEMBLY
ASSSEMBL
Y ORDER
£
Hanging Cabinet
£
Drawer Assembly
¢
Door Installation
£
Counters & Slat
Wall
75
