5.
For 14"D drawers, use two #6 x 1/2" wood screws
to attach each drawer runner to a drawer side. For
18"D drawers, use three #6 x 1/2" wood screws.
6. Place 14" or 18" Slide template into partition holes
(so arrow points forward) at desired drawer run-
ner location. Use a 5mm Self-Centering Drill Bit
to drill holes as marked in template. Attach each
drawer runner to partition with two (2) Euro screws.
7.
Use the charts below for standard drawer, basket
and hamper door combinations (“A” through “J”).
Start by placing the first set of drawer runners in the
first hole above the bottom fixed shelf.
Then, count holes again for each additional drawer or basket as shown in the chart below.
(See Basket Assembly for basket hole spacing.)
Fig. 4
8.
If drawer faces do not align properly, use shims and a level to raise or lower, as appropriate,
the relating partitions.
9.
You must install one fixed shelf after every three (3) drawers (as in combo C). For combinations
B, E, F, H, I and J, install the middle fixed shelf below the second drawer. (Middle fixed shelves
mount to the holes directly below the immediate drawer runner above.)
* Total Height from center to center of top and bottom fixed shelves.
SPACING GUIDE FOR 42” H
Drawer Spacing (Count Every X Holes) Drawer Spacing (Count Every X Holes)
Height B
C
D
E
Height F G H
I
J
6” 5th 5th 5th 5th
6”
-
5th 5th 5th
6”
-
5th 5th 5th
6”
-
5th 5th
-
6”
-
-
5th
-
10”
8th
8th
- 8th
10”
8th
-
-
-
10”
8th
-
-
-
Total
Drawer - 2
DOOR & DRAWER ASSEMBLY
49
SECTION
Height* 36-1/2" 35" 31-1/4" 28-5/8"
6” 5th - 5th 5th
5th
6”
5th
- 5th -
-
10”
8th 8th - 8th
8th
10”
8th 8th - - -
10”
- 8th - -
-
Hamper Door -
-
-
-
17"
-
-
- 3" Down -
-
-
-
-
- -
Total
Height* 32-1/4" 30" 36-1/2" 34-1/4" 40-1/4"
A B C
D E F G H I J
