INST
ALLA
TION
4.
Insert each hinge into a set of three (3) holes
on the back of the hamper door, then turn the
fastening screw one quarter turn clockwise (as
shown with arrows on the hinge) to tighten in
place. (See Fig. 2.)
Release
Button
Hooks
Fig. 2
Fig. 3
Fig. 4
5.
Position the Hamper Door face down on
the floor directly in front of the shelf tower.
Mount one flap stay on each side of the door
using the enclosed #8 x 5/8” screws. Attach
the basket hook (posts up) to the pre-drilled
holes in the door using the #8 x 1/2” screws
(required for solid wood doors).
6.
To fasten each hinge to a hinge plate, hold
the door with the hinges attached so that the
hooks on the back of each hinge latch onto
the front, leading edge of the mounted plate
(where the arrow is). Squeeze the two hinge
pieces until they snap together. (See Fig. 3.)
(Hinges may be separated by squeezing the
Release Button on the end of the arm.)
7.
Hold the door 90 degrees to the shelving unit
until the flap stays have been attached to the
partitions in the 7th and 8th system holes
(counting up from the bottom shelf) using
Euro screws. (See Fig. 4.)
8.
Choose your handle size and drill a 1/16"
pilot hole through each corresponding dimple
on the back of the hamper door. Then, from
the front of the door, drill a 3/16" hole for
handle at pilot location(s). NOTE: It is
important to drill both the pilot hole through
the back and the larger hole through the front
to prevent chipping. (See Fig. 4.)
Hamper Door - 2
DOOR & DRAWER ASSEMBLY
51
9.
Slide the 17” high wire basket onto the
basket hook and close the door.
NOTE: Door face may be adjusted left and right by loosening
the hinge plate’s fixing screws and sliding the door side to
side, then tightening the fixing screws again. The width of the
gap between the doors may be adjusted by tightening or
loosening the adjustment screw on the front of the hinge arm.
