PREP
ARA
TION
Shoe fences and angled shelves must be
installed as you are assembling and
installing the correlating shelf tower.
A shoe fence should be drilled and
fastened together with the shelf before
PAR
TS
QTY. PART DESCRIPTION
1+ Shoe fence (for either 24” or 30” shelves)
TOOLS
All standard closet tools, plus…
Shoe fence Template (#05-11818)
Self Center Drill Bit (#05-11619)
Rubber Mallet
INST
ALLA
TION
1. Place your cammed shelf, face up, on
a work surface to drill the hole pattern.
Hold the shoe fence template in place
on the top of the front (edgebanded) of
the shelf (Fig. 1).
it is installed in the tower. For angled shelving
with the fences, fasten the back screw-in studs
first, and then secure the front screw-in studs,
three holes below the back studs.
Use the Shoe Fence Template to guide your
drilling pattern on the top side of the shelf. The
template has hole patterns for shoe fence posts
to install on both 24” and 30” shelves.
Fig. 1
2. Using the Self Center Drill Bit, drill the three
holes through the template appropriate to
either the 24” or 30” shelf width.
Fig. 2
3. Position the shoe fence posts over the drilled holes.
Use a rubber mallet to drive the serrated post exten-
sions of the fence into the holes you just drilled. Be sure
to alternate each mallet hammer swing between each
end and middle post so that the post extensions fit into
the drilled holes straight up and down (and so that you
don’t bend the post extensions).
Shoe Fence
ACCESSORY ASSEMBLY
4. Install the shelf in the tower, fastening the back two cam locks, over the studs at three holes
above the height of the front cam locks and studs (Fig. 2).
Shelf will rest on front cam locks
only.
Do not lock front cam locks. Wipe down shelf.
62
ORDER OF ASSSEMBL
Y
£
Shelving /Towers
£
Drawers and
Doors
£
Top Shelves and Poles
£
Adjustable Shelves
£
Crown Molding
¢
Baskets, Valet Rods,
Tie & Belt Racks, and
other accessories
£
Islands
£
Benches
