POLE INST
ALLA
TION
1. Measure the distance between the
inside of the pole cup or bracket mounted
to the tower and the inside of the pole
cup or bracket mounted to the next
tower or sidewall.
2. Cut the pole to fit, using a pipe cutter.
3. Place the pole in the pole cups or
brackets.
3. After installing the full length top shelf,
measure, mark and cut the shorter connecting
top shelf material, subtracting the lengths
of the depth of the full length top shelf and
1/8” to 1/4” for the thickness of the 3/4”
Shelf Joiner. (See exploded view, Fig. 8.)
4. Fit your connecting top shelf into place
above the tower(s), sliding the Shelf Joiner
between the two perpendicular top shelf
pieces.
5. Screw in four (4) #8 x 1/2” screws through
the four (4) mounting holes on the underside
of the Shelf Joiner.
Installing Corbels
For pole spans wider than
36”
support the pole
using a corbel.
1. Push two slip-in studs through larger holes in
backside of cleat. (See Fig. 9.)
2. Fasten cleat to wall stud using two (2)
4.5 x 60 mm (2-3/8”) screws. (See Fig. 10.)
3. Drill a 1-1/8” hole in the half moon at
10-1/2” from back and 2-7/8” from the top.
(See Fig. 9.)
4. Push cam locks into cam holes in half moon.
(See Fig. 9.) Push cover caps over cams. Push
half moon over heads of slip-in studs sticking
out of cleat. Tighten cams.
5. Secure corbel to shelf with one (1)
#8 x 1-1/4” screw from above. (See Fig. 11.)
6. To connect 3/4” cammed top shelving
material in a corner (see Fig. 8 on previous
page), trim a 18” cammed shelf to fit the
gap, subtracting the width (1/8” – 1/4”) of
the 3/4” Shelf Joiner.
7. Fasten the custom cam shelf to the tower
on one wall. Slide the Shelf Joiner between
the unconnected end of the shelf and the
perpendicular top shelf of the adjacent
wall.
8. Fasten the four screws as in Step 5 to
secure the connection.
Fig. 11
4. Fasten the pole to the pole cups or
brackets using a #10 x 5/8” Self-Tapping
Screw through the slot in the underside
of each pole cup or bracket.
Top Shelf & Pole - 4
SHELVING/TOWER ASSEMBLY
47
CLEAT
CAM
HOLES
1-1/8”
10-1/2”
2-7/8”
Fig. 9
Fig. 10
