44-14
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 44 Configuring Network Admission Control
Configuring Network Admission Control with LAN Port IP
Setting EAPOUDP-Related Timers
To set EAPOUDP-related timers, perform this task in privileged mode:
The timer defaults and ranges are as follows:
•
aaa—The default is 60 seconds; the range is 1 through 60 seconds.
•
hold-period—The default is 180 seconds; the range is 60 through 86400 seconds.
•
retransmit—The default is 3 seconds; the range is 1 through 60 seconds.
•
revalidation—The default is 36000 seconds; the range is 5 through 86400 seconds.
•
status-query—The default is 300 seconds; the range is 30 through 1800 seconds.
This example shows how to set the revalidation timer to 200 seconds:
Console> (enable)
set eou timeout revalidation 200
Console> (enable)
Setting EOU Rate Limiting
To set EOU rate limiting (the default is 0 and the range is 10 through 200), perform this task in privileged
mode:
Note
The default rate limit value of 0 disables rate limiting. With rate limiting disabled, there is no limit on
simultaneous LAN port IP authentication sessions.
This example shows how to set EOU rate limiting to 40:
Console> (enable)
set eou rate-limit 40
eou ratelimit set to 40.
Console> (enable)
Task
Command
Set EAPOUDP-related timers.
set eou timeout aaa
aaa-timeout
set eou timeout hold-period
hold-timeout
set eou timeout retransmit
retransmit-timeout
set eou timeout revalidation
revalidation-timeout
set eou timeout status-query
status-query-timeout
Task
Command
Set EOU rate limiting.
set eou rate-limit
ratelimit
