Cisco Broadband Cable, Справочное руководство, Страница: 909 / 1278

5-49
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 5 Cisco CMTS Debugging Commands
debug cable mac-address
Related Commands
Table 5-3 debug cable mac Command Field Descriptions
Field Description
SID value is.... Reports the service ID of the modem. The range is from 1 through
891. The information on this line should agree with the first line of
the return (that is, Ranging Modem with Sid...).
CM mac address.... The MAC address of the specified CM.
Timing offset is.... The time by which to offset the frame transmission upstream so that
the frame arrives at the expected minislot time at the CMTS.
Power value is FE0, or 0 dB The raw value derived from the 3137 Broadcom chip. Alternatively,
the dB value specifies the relative change in the transmission power
level that the CM needs to make sure that transmissions arrive at the
CMTS at the desired power level.
Freq Error = .... The raw value derived from the 3137 Broadcom chip.
Freq offset is .... Specifies the relative change in the transmission frequency that the
CM will make to match the CMTS.
Command Description
debug cable dynsrv Displays debugging information about DOCSIS 1.1 dynamic service
flow messages.
debug cable interface Enables debugging output for a specific cable interface.
debug cable mac-protocol Displays debugging output for the MAC layer protocol.
debug cable mac-scheduler Displays debugging output for the MAC layer scheduler and
admission control activities.
debug cable registration Displays debugging output for the registration messages sent when a
CM comes online with the CMTS.
debug cable tlvs Enables debugging for the Type/Length/Value encodings (TLVs)
parsed by the DOCSIS 1.1 TLV parser/encoder.
show controllers cable Displays interface controller information for the specified slot.