
2-351
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 2 Cisco CMTS Configuration Commands
cable upstream snr-polling
cable upstream snr-polling
To configure how often cable interface cards with hardware spectrum management should poll an
upstream to determine its Carrier-to-Noise Ration (CNR), use the
cable upstream snr-polling
command
in cable interface configuration mode.
cable upstream
n
snr-polling
interval-in-ms
Note
This command can be used only on upstreams on the Cisco uBR-MC16S cable interface line cards.
Syntax Description
Defaults
5000 milliseconds
Command Modes
Interface configuration (cable interface only)
Command History
Usage Guidelines
The Cisco uBR-MC16S cable interface line cards contain digital signal processors (DSPs) that perform
hardware spectrum management. Use the
cable upstream snr-polling
command to determine how often
that hardware should examine an upstream’s signal to determine the current CNR value.
Examples
The following example shows how to configure the sixth upstream on a Cisco uBR-MC16S cable
interface card so that the DSP samples the upstream signal every 10 seconds (10,000 milliseconds):
Router(config)#
interface cable 3/0
Router(config-if)#
cable upstream 5 snr-polling 10000
Router(config-if)#
Related Commands
n
Specifies the upstream port number. Valid values start with 0 for the
first upstream port on the cable interface line card.
interval-in-ms
The valid range is 1000 to 25000 milliseconds, with a default of 15000
milliseconds.
Release
Modification
12.1(7)CX1
This command was introduced for Cisco CMTS routers using the
Cisco uBR-MC16S cable interface line card.
12.2(8)BC2
Support was added for the Cisco uBR10012 router and the
Cisco uBR-LCP2-MC16S cable interface line card.
Command
Description
cable modulation-profile
Creates a cable modulation profile.
cable upstream
modulation-profile
Configures an upstream for one modulation profile (static profile) or two
modulation profiles (Dynamic Upstream Modulation).
Содержание Broadband Cable
Страница 760: ...3 264 Cisco Broadband Cable Command Reference Guide OL 1581 08 Chapter 3 Cisco CMTS Show Commands show version ...
Страница 1216: ...6 214 Cisco Broadband Cable Command Reference Guide OL 1581 07 Chapter 6 Cable CPE Commands debug usb ...
Страница 1266: ...A 50 Cisco Broadband Cable Command Reference Guide OL 1581 07 Appendix A Using the ROM Monitor unset ...