Cisco Broadband Cable, Справочное руководство, Страница: 1277 / 1278

Index
IN-11
Cisco Broadband Cable Command Reference Guide
OL-1581-07
show interface cable signal-quality command 3-241
show interface cable upstream command
3-243
show interfaces cable-modem command
6-165
show interfaces usb command 6-172
show packetcable event command 3-250
show packetcable global command
3-257
show processor cpu command
4-67
show pxf cable command 4-53
show pxf cable interface command 4-58
show pxf cpu command
4-61
show pxf dma command
4-78
show pxf microcode command 4-85
show pxf xcm command 4-88
show redundancy command
4-91
show tech-support command
3-259
show version command 3-262
show voice port command 6-177
SIDs
debugging
5-91
sniffing packets on the cable interface 2-175
SNMP
enabling cable-related traps
2-477, 2-479
enabling cable traps
2-477
enabling CM state change traps 2-78
enabling DOCSIS traps 2-479
polling CMs
2-162
setting default values for the Subscriber Management
MIB
2-244
specifying a manager in the DOCSIS configuration
file
2-475
snmp manager command
2-475
snmp-server enable cable command
2-477, 2-479
snmp-server enable traps cable command 2-477
snmp-server enable traps docsis-cmts command
2-479
software configuration boot register
A-14
specifying the maximum number of hosts
2-149
spectrum group
configuring shared spectrum groups
2-242
configuring the hop period
2-237
configuring the hop threshold value 2-239
creating
2-231, 2-235, 2-349
debugging
5-38
displaying 3-154, 3-176
spectrum management
debugging
5-91
stack command
A-42
switchover pxf restart command 4-96
switchover timeout command 4-98
sync command
A-44
SYSLOG server
DOCSIS messages 2-83
sysreset command A-45
system messages
logging BAD IP source address messages
2-143
T
T9 timer, setting
2-203
TCC+ card
clearing clock counters 2-22
displaying clock reference information
3-180
displaying clock reference status
3-15
displaying TDM clock reference 3-192
selecting external timing source 2-24
setting midplane clock reference
2-26
TEK, setting values
2-190
telco-return
enabling 2-250
enabling DHCP server
2-256
setting for manual-dial mode
2-264
setting the authentication method 2-270
setting the authentication password 2-266
setting the authentication username
2-278
setting the default SPD value
2-262
setting the idle timeout value 2-260
setting the RADIUS server 2-272
setting the registration IP addresses
2-254
setting the service provider name
2-274