Cisco Broadband Cable, Справочное руководство, Страница: 1180 / 1278

6-178
Cisco Broadband Cable Command Reference Guide
OL-1581-07
Chapter 6 Cable CPE Commands
show voice port
Voice card specific Info Follows:
Signal Type is loopStart
Ring Frequency is 25 Hz
Hook Status is On Hook
Ring Active Status is inactive
Ring Ground Status is inactive
Tip Ground Status is inactive
Digit Duration Timing is set to 100 ms
InterDigit Duration Timing is set to 100 ms
Router#
Table 6-34 describes the fields shown in this display.
Table 6-34 show voice port Field Descriptions
Field Description
Type of VoicePort Type of voice port: always FXS for the cable access router.
Operations State Operation state of the port.
Administrative State Administrative state of the voice port.
Interface Down Failure Last interface down failure that was reported, if any.
Description Description of the voice port, if any.
Noise Regeneration Whether or not background noise should be played to fill silent
gaps if VAD is activated.
Non Linear Processing Whether or not nonlinear processing is enabled for this port.
Music On Hold Threshold Configured music-on-hold threshold value for this interface.
In Gain Amount of gain inserted at the receiver side of the interface.
Out Attenuation Amount of attenuation inserted at the transmit side of the interface.
Echo Cancellation Whether or not echo cancellation is enabled for this port.
Echo Cancel Coverage Echo cancel coverage for this port.
Connection Mode Connection mode of the interface.
Connection Number Full E.164 telephone number used to establish a connection with
the trunk or PLAR mode.
Initial Time Out Amount of time the system waits for an initial input digit from the
caller.
Interdigit Time Out Amount of time the system waits for a subsequent input digit from
the caller.
Call-Disconnect Time Out Number of seconds for an idle call to be disconnected.
Ringing Time Out Ringing time out duration.
Region Tone Configured regional tone for this interface.
Currently Processing Type of call currently being processed: none, voice, or fax.
Maintenance Mode Maintenance mode of the voice port.
Number of signaling protocol
errors Number of signalling protocol errors.
Impedance Configured terminating impedance for the E&M interface.