Cisco Broadband Cable, Справочное руководство

Страница: 1067 / 1278

6-65
Cisco Broadband Cable Command Reference Guide
OL-1581-07
Chapter 6 Cable CPE Commands
port (dial-peer)
port (dial-peer)
To associate a dial peer with a specific voice port, use the port dial-peer configuration command. To
cancel this association, use the no form of this command.
Cisco uBR924, uBR925 cable access routers, Cisco CVA122 Cable Voice Adapter
port number
no port number
Note For complete details on this command for all supported platforms, see the Cisco IOS Voice, Video, and
Fax Command Reference, Release 12.2 , available on Cisco.com .
Syntax Description:
Defaults No port is configured.
Command Modes Dial-peer configuration
Command History
Usage Guidelines
This command is used for calls incoming from a telephony interface to select an incoming dial peer and
for calls coming from the VoIP network to match a port with the selected outgoing dial peer.
Note This command applies only to POTS peers.
number Specifies one of the RJ-11 voice port connectors installed in the router. Valid
entries are 0 (which corresponds to the RJ-11 connector labeled V1) and 1
(which corresponds to the RJ-11 connector labeled V2).
Release Modification
11.3(1)T This command was introduced (Cisco 3600 series router).
11.3(3)T Support was added for the Cisco 2600 router.
11.3MA Support was added for the Cisco MC3810 multiservice concentrator.
12.0(3)T Support was added for the Cisco AS5300 universal access server.
12.0(4)T Support was added for the Cisco uBR924 cable access router.
12.0(7)T Support was added for the Cisco AS5800 universal gateway.
12.1(5)XU1 Support was added for the Cisco CVA122 Cable Voice Adapter.
12.2(2)XA Support was added for the Cisco uBR925 cable access router.