Cisco Broadband Cable, Справочное руководство

Страница: 274 / 1278

2-262
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 2 Cisco CMTS Configuration Commands
cable telco-return spd factory-default
cable telco-return spd factory-default
To indicate the service provider descriptor (SPD) that the telco-return CM uses during the initialization
process, use the
cable telco-return spd factory-default command in cable interface configuration
mode. To restore the default value, use the no form of this command.
cable telco-return spd spd-number factory-default
no cable telco-return spd spd-number factory-default
Syntax Description
Defaults The Factory Default Flag in the SPD is set to 0, which means that this SPD is not used for the
initialization process.
Command Modes Interface configuration (cable interface only)
Command History
Usage Guidelines This command sets the Factory Default parameter in the specified SPD in Telephony Channel Descriptor
(TCD) messages. This determines the set of telephony attributes, as defined by the SPD, that are used
for the initialization process when the CM is powered on or is reset to its factory default.
Note
This command is available only in images that support telco-return. These images have a “t” as part of
the image name.
Examples The following example shows how to set the telco-return CM to use SPD 2 during the initialization
procedure:
router(config-if)# cable telco-return spd 2 factory-default
Related Commands
spd-number Service provider descriptor (SPD) that contains the set of telephony
attributes used by the CM during initialization. Valid range is 1
through 5.
Release Modification
12.0(4)XI This command was introduced.
Command Description
cable telco-return enable Enables telco-return functionality.
cable telco-return interval Defines the interval for sending TCD and Termination System
Information (TSI) messages.
cable telco-return
registration-ip Selects a different IP address for the telco-return CM to send its
registration requests.