4
FI002K0018v1530hUK – THS/21 Instruction manual for installation, use and maintenance
USE OF THE DEVICE
152 ORIGINAL
INSTRUCTION
4.3.3 Signals at power-up
The detector is designed to be switched on directly from the electrical panel that controls the
production line.
Control Panel
The presence of mains
power supply is signalled by
the lighting up of the
indicator located on the
control panel. On the
Conveyor Control System
this is also indicated by a
warning light on the door of
the box.
Conveyor Control System
When the device is turned on, the display lights up, as do the indicators located on
the front of the electronics unit.
The display shows, in sequence, the serial number and the version of the software program that
drives the power supply unit.
On integrated systems, the display shows the message EMERGENCY RESET and waits for you to
press the Emergency Reset key.
After this the following display appears:
THS/xx21E
THS/xx21E V5.xxx
Prod. PROD01
^
The first line identifies the model and the software version of the
Metal Detector. The second line indicates the type of programming,
specific to one product which may be chosen from among 250 stored
sets.
THS/xx21
CEIA THS/xx21
ALM V5.xxx THS V5.xxx
Product:PROD01
The first line identifies the model. The second line identifies the
software version of the Metal Detector. The last line indicates the
type of programming, specific to one product which may be chosen
from among 500 stored sets.
On models where a Remote Control Unit
is installed (because the Probe is installed in a position which is not
accessible to the operator), the control panel on the Probe is disabled (the message “Remote control ON” appears).
