5
FI002K0018v1530hUK – THS/21 Instruction manual for installation, use and maintenance
MAINTENANCE
186 ORIGINAL
INSTRUCTION
5.5.1 General
compatibility
check
This command performs a complete set of automatic checks to verify the general environmental
compatibility of the Metal Detector (for electrical and/or mechanical noises) with the system where it
is installed and with the environment, in normal operating conditions and without product in transit.
- Ensure that the same product, with which the noise has been detected during the normal
operations, is selected.
- Access the programming phase on
Configuration > Compatibility chk >
Gener.comp.check
menu and press the E key to start the procedure. The Metal Detector will
ask to stop or to restart the machines in question to move the product into the line, or working
in the Metal Detector nearby, following the sequence described below.
Step 1
Step 2
Step 3
Step 4
Transport stopped
Transport stopped
Transport running
Transport running
During the procedure the execution of more steps may be requested.
- At the end of the procedure the Metal Detector indicates the estimated degree of
environmental compatibility:
INSUFFICIENT
/
SUFFICIENT
/
GOOD
. This result takes into
account the actual Metal Detector settings; however, its correct functionality needs to be
verified, including with product in transit.
5.5.2 Electrical Compatibility check
This command performs a complete set of automatic checks to verify the environmental compatibility
of the Metal Detector (for electrical noises only) with the system where it is installed and with the
environment, in normal operating conditions and without product in transit.
- Ensure that the same product, with which the noise has been detected during the normal
operations, is selected.
- Access the programming phase on
Configuration > Compatibility chk >
Gener.comp.check
menu and press the E key to start the procedure. The Metal Detector will
ask to stop or to restart the machines in question to move the product into the line, or working
in the Metal Detector nearby, following the sequence described below.
Step 1
Step 2
Transport stopped
Transport running
During the procedure the execution of more steps may be requested.
- At the end of the procedure the Metal Detector indicates the estimated degree of
environmental compatibility:
INSUFFICIENT
/
SUFFICIENT
/
GOOD
. This result takes into
account the actual Metal Detector settings; however, its correct functionality needs to be
verified, including with product in transit.
