Chapter 2: System hardware
70
Status information provided
LED
Color when active
SM / BHS in
“Operating”
Mode
SM / BHS in “Aiming” Mode
Note
(10/100/1000)
data transfer.
Frequency of flash
is not a diagnostic
indication.
10BASE-T = Red
100BASE-T =
Green
1000BASE-T =
Orange
Table 42 :3 GHz 450b SM/BHS LED descriptions
Status information provided
LED
Color
when
active
SM / BHS in
“Operating”
Mode
SM / BHS in “Aiming” Mode
Note
PWR
Blue
DC power
Always lit after power on
ETH
Red /
Green /
Orange
(10 /
100 /
1000)
Ethernet Link
Flashes during data
transfer. Frequency of
flash is not a diagnostic
indication. 10Base-T =
Red
100BASE-T = Green
1000BASE-T = Orange
SES/
SYN
Yellow
/ Green
Session
status: -
Scanning =
Blinking
yellow
Registering
= Solid
yellow
Registered
= Solid
green
This LED indicates when the signal level is
sufficient for normal operation. When the
power rises above this threshold, the LED
color changes from Yellow to Green.
Содержание PMP 450 Series
