204
5
Select [Ethernet Frame Size], then click [OK].
Notes:
• To use the TeraStation with jumbo frames, your router/switch/hub must support jumbo frames.
• To use jumbo frames (4102/7422/9216 bytes), your computer's NICs and all switches, hubs, and routers on the
transmission route need to support jumbo frames. If any device on the route does not support jumbo frames,
use standard frames (1518 bytes) instead.
• If the TeraStation is being used as an iSCSI hard drive, to change the settings, navigate to [Drives] - [iSCSI] in the
Web Admin interface and set the icon to
.
If
is displayed, change the icon to
. After changing the settings, click it again to return it to
.
This completes the setup.
Changing the IP Address
Normally, the TeraStation's IP address is set automatically from a DHCP server on your network. If you prefer, you can
set it manually. To change the TeraStation's IP address settings, your computer should be connected to the same router
(subnet) as the TeraStation and should be running NAS Navigator2.
Notes:
• NAS Navigator2 can only be used to change LAN ports that are connected to the same network subnet as
the computer. To change the LAN port on a different local area side, change the IP address by navigating to
[Network] - [IP Address] in the Web Admin interface.
• If the TeraStation is being used as an iSCSI hard drive, to change the settings, navigate to [Drives] - [iSCSI] in the