Brother GTX pro, Инструкция по эксплуатации, Страница: 302 / 356

302
Troubleshooting
(17) Tighten the nut firmly until it stops so that each tube is fixed to the print head.
<IMPORTANT>

Be sure not to tighten the nut for part (a) by mistake.
M4
4
3
2
1
C3
Y2
Bk1
X0415
(18) Close the front cover, turn on the power.
(19) From the menu, select [Maintenance] > [Install Ink after Replacing Head] > [White], and press .
Perform the work operation by following the on-screen instructions.
<TIPS>

When the white ink pouch runs low on its remaining volume of white ink, the Install Ink after Replacing Head function can
no longer get started. Furthermore, there may be cases where the pouch needs to be replaced with a new one during the
installation process of white ink. If the remaining volume is 400 g (14.1 oz) or less, prepare a new white ink pouch, follow
the instructions on the screen to replace the pouch, and activate the mode again.
(20) On the operation panel, press .
Then, the white ink will be installed after the head is replaced with a new one.
<TIPS>

After the procedures are completed, the current screen will go back to the standby mode screen.
(21) Adjust the carriage speed.
☞
"7-4-1. CR (Carriage) speed adjustment >>P.216"
(22) Print the nozzle check patterns.
☞
"7-2-1. Print out of the nozzle check pattern (checking on the print heads)
>>P.199"
(23) Perform the initial settings after head replacement configuration.
☞
"7-4-2. Initial settings after head replacement
>>P.217"
(24) Adjust the ejection timing of the print head.
☞
"7-4-3. Firing adjustment >>P.218"
(25) Perform the platen feed adjustment.
☞
"7-4-4. Platen-rolling adjustment >>P.219"
(26) Make the position adjustment between the white head and the color head.
☞
"7-4-5. White/color alignment
>>P.220"
Tube
(a)
Print head
Nut
*Remove the ink clot.