Brother GTX pro, Инструкция по эксплуатации, Страница: 254 / 356

254
Troubleshooting
Thin color cannot be printed out well gradually
Probable Cause Remedy Reference
Is the ambient atmosphere at a
high temperature and very dry,
which in turn tends to cause the
nozzle surface to dry up? Perform the flushing more frequently. In addition,
increase the flushing volume. "8-13. Flushing Interval
Setting >>P.236"
"8-14. Flushing Volume
Setting >>P.236"
White ink is not printed out evenly
Probable Cause Remedy Reference
Has the pretreatment been
applied unevenly? Apply the recommended amount of pretreatment
evenly to the target area. "6-3-3. Application of
pretreatment >>P.126"
Has the pretreatment caused any
change in hardness or
deformation of the pretreatment
roller? (This applies to the case
where the pretreatment roller is
used.) After the pretreatment roller is used, put it in a plastic
bag or the like hermetically to prevent it from drying
up, and keep it in a flat place in an upright position.
Also, when it remains unused for two weeks or
longer, wash it well with running water, and let it dry in
a shaded area.
-
Is any water content attached to
the pretreatment roller after the
pretreatment is fixated? Prevent water content from being attached to the
roller after the pretreatment is fixated. "6-3-4. Fixation of
pretreatment >>P.132"
Is there any lint, yarn waste, dust,
etc. that are attached to the
surface of pretreatment roller?
(This applies to the case where
the pretreatment roller is used.) Clean the surface of the pretreatment roller. "6-3-3. Application of
pretreatment >>P.126"
Did you shake the pretreatment
after its dilution? Shake the pretreatment sufficiently. "6-3-2. Dilution of
pretreatment >>P.124"
Is the [Low Temperature Mode]
set to [Disable]? Change the setting to [Enable (Normal)]. "8-11. Print Operation
Settings Under Low
Temperature >>P.234"
Has the pretreatment been fixated
insufficiently? Check on an actual temperature of the heat press
and its pressure during the fixation stage.
Always keeping the lower iron (where media is
placed) of the heat press at heated temperature with
a heating source may solve this problem. "6-3-4. Fixation of
pretreatment >>P.132"
Whiteness of print result is insufficient
Probable Cause Remedy Reference
Has the pretreatment been
applied insufficiently? Apply a proper amount of pretreatment. "6-3-3. Application of
pretreatment >>P.126"
Has the pretreatment been fixated
insufficiently? Check on an actual temperature of the heat press
and its pressure during the fixation stage. "6-3-4. Fixation of
pretreatment >>P.132"
Is there any nozzle that does not
eject ink-jet droplets?
Perform [Head Cleaning] from the menu.
If no improvement is attained, follow the referenced
instructions. "9-2-1. Recovery action to
be taken for such a nozzle
that is unable to eject
ink-jet droplets >>P.257"
Is the white ink circulated
insufficiently?
From the menu, select [Maintenance] > [White Ink
Circulation] to circulate the white ink properly.
-