Brother GTX pro, Инструкция по эксплуатации, Страница: 255 / 356

255
Troubleshooting
Probable Cause Remedy Reference
Is the white ink stirred
insufficiently? In the event that the white ink remains accumulated in
the bottom of the ink pouch, shake the pouch 100
times and additionally shake it until the ink is stirred
well.
Also, when the remaining ink level becomes
approximately 5.9 in. (15 cm), shake the cartridge
with its cover open and with the edge of the ink pouch
slightly winded.
-
Is the [Low Temperature Mode]
set to [Disable]? Change the setting to [Enable (Normal)]. "8-11. Print Operation
Settings Under Low
Temperature >>P.234"
Is the dilution rate of the
pretreatment correct? Dilute the pretreatment appropriately. "6-3-2. Dilution of
pretreatment >>P.124"
Is the [Highlight:] of [White Ink
Settings:] too low? Print the highlight check pattern to check the blurring,
and select appropriate set value for [Highlight:]. "5-5-6. Print out of
highlight check
pattern/mask check
pattern >>P.110"
"5-4-4. Set up the white
ink >>P.94"
Too much luster
Probable Cause Remedy Reference
Are you using Teflon-treated
peel-off sheet for fixation? Use a silicon coated peel off sheet when curing the
ink to reduce the gloss.
-
Too fuzzy
Probable Cause Remedy Reference
Did you touch the print media
(T-shirt) just before printing? Excessively touching the media (T-shirt) on the
platen by trying to flatten the media before printing
could cause fuzziness. Make sure not to touch the
media surface too much after the pretreatment is
fixated.
-
Does it take a long time before
printing, after the pretreatment
fixation? Leaving the print media (T-shirt) after fixing the
pretreatment may cause fuzziness, because the
media would absorb water. Print the pretreatment
fixated media as soon as possible.
-
Is the upper iron on the heat press
contaminated during the
pretreatment fixation process? If the upper iron is contaminated, it could roughen the
print media (T-shirt) surface by a heat press process,
to cause fuzziness. Clean the upper iron of the heat
press with a cloth.
If the condition persists, try using a peel-off sheet
during the pretreatment fixation process, to probably
improve the condition.
-
Unevenly dried during the fixation
process? It may be solved by inserting a silicone foam
between the heat press lower iron and a print media
(T-shirt) during ink fixation.
-