Brother GTX pro, Инструкция по эксплуатации, Страница: 267 / 356

267
Troubleshooting
(7) Open the lid of the cartridge and place the ink pouch in its correct position.
<IMPORTANT>

Always open the cartridge lid and properly rewind the ink pouch. If the pouch is placed without opening the lid, ink can flow
into the wound section of the pouch when stirred, which can cause improper winding of the pouch.

When opening the lid, place the entire cartridge on a flat surface, push the latches on the bottom surface of the cartridge
downward and open the lid.

When setting the ink pouch, avoid unevenness or wrinkles on the pouch.

When opening the lid, be sure not to touch the portion (a). Otherwise, it could be damaged.
<NOTE>

If the remaining ink level is low, hold the sagged part of the ink pouch and close the lid.
(a)
X0182
X0078
X0142
(8) Close the lid, and put the white ink cartridge in position inside the printer.
<IMPORTANT>

W12 and W34 cartridges should correctly be placed in their original locations. Wrongly placed cartridges could cause a
printer malfunction.
(9) Repeat the same process to replace the other maintenance solution cartridge with the white ink pouch.
(10)
Check the waste ink tank level and take any necessary measure for it, if any, then press on the operation panel.
After the cleaning is completed, the Install White Ink After Cleaning function will get started.
<TIPS>

The "Install White Ink After Cleaning" operation will take approximately 15 minutes. After the procedures are completed, the
current screen will go back to the standby mode screen.
Place the pouch in a straight alignment with the cartridge
Latch Lid
No wrinkles
Not sagged
Ink pouch
Lid
Cartridge