3.5.3 Setting reset totals
IMPORTANT
If the totalizer lock is enabled, the previous totals will not
be cleared by this process.
To reset the totals, refer to
Figure 57
below and proceed as
follows:
NOTE:
If necessary, refer to
as a
reminder about color code meanings.
1. Refer to
and navigate to
Page 4: configuration (generic).
2. Use the [
] and [
] keys to highlight
reset totals
and
press the [
] key twice to confirm your choice.
3. At the next screen, use the [
] and [
] keys to highlight
either the
reset both
or
reset fwd totals
or
reset rev totals
option. Then, press the [
] key to confirm your selection
or press the [
] key to cancel and return to the previous
screen.
Figure 57: Resetting the fwd and/or rev totals
Legend
Green
At least user 3 level access required to follow the step.
Dotted
green
Not all transitional screens are shown (at least user 3 level
access required).
Red
Option only visible to user 1 or above.
Green
Option only visible to user 3 or above.
50
Содержание Panametrics Sentinel LCT8
