3.3.3.2 Changing the access level from user configurations
To change the access level from
user configurations
, refer to
Figure 42
below and complete the following steps:
NOTE:
If necessary, refer to
as a reminder about color code meanings.
1. Refer to
and navigate to
page 8: user configurations
.
2. Use the [
] and [
] keys to highlight the set security
option. Then, press the [
] key to access the security
options list (at least user1 access level is required).
3. Use the [
] and [
] keys to highlight the desired security
level option.
4. Press the [
] key twice confirm your selection.
NOTE:
The example screens shown above are for admin level
access. The options vary for other access levels.
NOTE:
The arrows in this figure are red and indicate at least user 1 access level is required to follow these steps.
NOTE:
The options shown are based on
user admin access. Other access level
options vary.
Use
or
arrow to highlight the
“security level” option you want to select
and press
twice to confirm selection.
Figure 42: Setting the security level from user configurations
28
Содержание Panametrics Sentinel LCT8
