Atmel SAM4S Series, Предварительный информационный лист

Страница: 350 / 1163

350
11100B–ATARM–31-Jul-12
SAM4S Series [Preliminary]
20.2.5 Device Operations
Several commands on the Flash memory are available. These commands are summarized in
Table 20-3 on page 347 . Each command is driven by the programmer through the parallel inter-
face running several read/write handshaking sequences.
When a new command is executed, the previous one is automatically achieved. Thus, chaining
a read command after a write automatically flushes the load buffer in the Flash.
In the following table:
• DATA[15:0] pertains to SAM4SxB/C (64/100 pins)
20.2.5.1 Flash Read Command
This command is used to read the contents of the Flash memory. The read command can start
at any valid address in the memory plane and is optimized for consecutive reads. Read hand-
shaking can be chained; an internal address buffer is automatically increased.
20.2.5.2 Flash Write Command
This command is used to write the Flash contents.
The Flash memory plane is organized into several pages. Data to be written are stored in a load
buffer that corresponds to a Flash memory page. The load buffer is automatically flushed to the
Flash:
9 Sets NOE signal Output
10 Waits for NVALID high Sets DATA bus in input mode X
11 Sets DATA in output mode Sets NVALID signal Input
12 Sets NCMD signal Waits for NCMD high Input
13 Waits for RDY high Sets RDY signal Input
Table 20-5. Read Handshake (Continued)
Step Programmer Action Device Action DATA I/O
Table 20-6. Read Command
Step Handshake Sequence MODE[3:0] DATA[15:0]
1 Write handshaking CMDE READ
2 Write handshaking ADDR0 Memory Address LSB
3 Write handshaking ADDR1 Memory Address
4 Read handshaking DATA *Memory +
5 Read handshaking DATA *Memory +
... ... ... ...
n Write handshaking ADDR0 Memory Address LSB
n+1 Write handshaking ADDR1 Memory Address
n+2 Read handshaking DATA *Memory +
n+3 Read handshaking DATA *Memory +
... ... ... ...