13
12. Remove the oil level stick; the engine oil level should
be above the illustrated “L” mark but not higher than
the illustrated “F” mark.
ATV-0100AA
13. Inspect the area around the drain plug and oil filter
for leaks.
14. Install the left-side engine cover and the seat.
Front Differential/Rear
Drive Lubricant
When changing the lubricant, use approved SAE 80W-90
hypoid gear lube.
To check lubricant, remove the rear drive filler plug; the
lubricant level should be 1 in. below the threads of the
plug. If low, add SAE approved 80W-90 hypoid gear
lubricant as necessary.
To change the lubricant, use the following procedure.
1. Place the ATV on level ground; then remove each fill
plug.
KC0077A
2. Drain the lubricant into a drain pan by removing the
drain plug from each.
ATV0082A
737-651B
3. After all the oil has been drained, install the drain
plugs and tighten to 45 in.-lb.
4. Pour the appropriate amount of approved SAE
80W-90 hypoid gear lubricant into the filler hole.
5. Install the fill plugs and tighten to 16 ft-lb.
NOTE: If the differential/rear drive oil is contami-
nated with water, inspect the drain plug, filler plug,
and/or bladder.
Tires
TIRE SIZES
The ATV is equipped with low-pressure tubeless tires of
the size and type listed (see General Information section).
Do not under any circumstances substitute tires of a dif-
ferent type or size.
TIRE INFLATION PRESSURE
Front and rear tire inflation pressure should be 27.6 kPa
(4.0 psi).
CAUTION
Do not over-fill the engine with oil. Always make sure
that the oil level is above the “L” mark but not higher
than the “F” mark.
CAUTION
Water entering the outer end of the axle will not be able
to enter the rear drive unless the seals are damaged.
! WARNING
Always use the size and type of tires specified. Always
maintain proper tire inflation pressure.
Manual
Table of Contents
