54
FI646
FI653A
4. Remove the gear shift shaft (F) noting the inner and
outer washers.
FI650A
5. Remove the countershaft assembly (E) along with
the shift fork assembly.
FI662
6. Remove the crank balancer driven gear (G) and
account for a key; then remove the crankshaft bal-
ancer shaft.
MD1024
7. Using Crankcase Separator/Crankshaft Remover
with the appropriate crankshaft protector, remove the
crankshaft.
MD1330
8. Remove the secondary drive gear/secondary driven
gear retaining nut. From inside the crankcase using a
rubber mallet, drive out the output shaft assembly.
Account for the output shaft, a shim, a washer, and
the nut.
Servicing Center
Crankcase Components
NOTE: Whenever a part is worn excessively,
cracked, damaged in any way, or out of tolerance,
replacement is necessary.
CAUTION
Do not remove the remaining output shaft assembly
unless absolutely necessary. If the shaft is removed, the
shaft nut must be replaced with a new one and the shaft
must be re-shimmed.
AT THIS POINT
To service crankshaft assembly, see Servicing Center
Crankcase Components sub-section.
Manual
Table of Contents
