25
FI522A
11. From the right side, disconnect the stator connector
(H) and crankshaft position sensor connector (I)
from the main harness; then disconnect the positive
cable from the starter motor and the engine ground
cable from the starter mounting flange.
FI523A
FI533A
12. Remove the screws securing throttle arm cover to the
throttle body; then loosen the throttle cable jam-nut
and remove the throttle cable.
FI536A
13. Remove the cap screws securing the exhaust pipe to
the cylinder head; then remove the springs securing
the muffler to the exhaust pipe.
14. Remove coolant hoses (A) and (B) from the water
pump; then remove the upper coolant hose from the
thermostat housing.
FI530B
FI537
15. Remove the cap screws securing the front and rear
drivelines to the output drive flange.
16. Support the engine and remove the two through bolts
securing the engine assembly to the frame; then
move the engine rearward sufficiently to disengage
the front driveline and remove the engine from the
left side.
Top-Side Components
NOTE: For efficiency, it is preferable to remove and
disassemble only those components which need to
be addressed and to service only those components.
The technician should use discretion and sound
judgment.
NOTE: The engine/transmission does not have to
removed from the frame for this procedure.
AT THIS POINT
To service any one specific component, only limited dis-
assembly of components may be necessary. Note the
AT THIS POINT information in each sub-section.
Manual
Table of Contents
