15
KC163B
5. Connect the wiring harness connector to the bulb;
then install the protective rubber boot making sure it
seals completely on the headlight harness.
KC146
TAILLIGHTS-BRAKELIGHTS
To replace a taillight-brakelight bulb, use the following
procedure.
1. Turn the bulb socket assembly counterclockwise and
remove from the housing.
KC157
2. Press in and turn the bulb counterclockwise to remove.
Press in and turn clockwise to install the bulb.
3. Insert the bulb socket assembly into the housing and
turn it clockwise to secure.
RUNNING LIGHTS/BACK-UP LIGHTS
The running lights are located outboard of the headlights,
and the back-up lights are outboard of the taillights/brake-
lights. To replace the bulbs, use the following procedure.
1. Rotate the bulb socket counterclockwise to release
from light housing; then press in on the bulb and turn
counterclockwise to release from the socket.
KC158A
2. Install a new bulb and press in rotating clockwise to
secure; then place the socket into the light housing
and turn clockwise to secure.
KC158B
CHECKING/ADJUSTING HEADLIGHT
AIM
The headlights can be adjusted vertically and horizon-
tally. The geometric center of the HIGH beam light zone
is to be used for vertical and horizontal aiming.
1. Position the ATV on a level floor so the headlights
are approximately 6.1 m (20 ft) from an aiming sur-
face (wall or similar aiming surface).
ATV-0070C
NOTE: There should be an average operating load
on the ATV when adjusting the headlight aim.
2. Measure the distance from the floor to the mid-point
of each headlight.
Manual
Table of Contents
