90
KC314
9. Support the axle to not allow it to drop or hang.
10. Pull out on the axle until completely extended; then
push it back in approximately one half inch and pull
out sharply. Repeat until axle spline dislodges from
the gear case.
KC425A
NOTE: In some instances it may be necessary to
use a pry-bar between the gear case housing and
axle coupler shoulder to dislodge the splines.
KC426A
11. Remove the cap screws from the drive coupler
flange; then remove the upper and lower mounting
cap screws and remove the differential from the
frame.
KC291A
Disassembling Input Shaft
NOTE: This procedure can be performed on a rear
gear case; however, some components may vary
from model to model. The technician should use dis-
cretion and sound judgment.
1. Remove the cap screws securing the front drive actu-
ator and remove the actuator.
CD102
2. Remove the cap screws securing the pinion housing;
then using a rubber mallet, remove the housing.
Account for a gasket. Remove the fork, collar, and
spring. Note the location of all the components for
assembling purposes.
CD103
CAUTION
The axle must be supported. If the axle is allowed to
drop or hang, damage to the inner CV joint may occur.
Manual
Table of Contents
