3Com 3C63400-3AC-C - PathBuilder S700 Switch, Справочное руководство

Страница: 205 / 272

Configuring Virtual Circuits 191
4 Follow the prompts that appear at the bottom of the screen, pressing [Enter] after
each entry. Default values are listed in square brackets ([ ]) at the end of each
prompt.
Your settings are added to the list of parameters at the top of the screen as you
enter them. You must enter a setting for all the parameters for which you are
prompted in order to add a circuit. Press [Delete] to back up to a previous
selection.
Some parameters that appear on the Add Virtual Circuit screen may not apply to
the particular circuit you are configuring. The system skips any non-applicable
parameters and does not allow you to set them. In addition, certain parameters
may be displayed for information only; you cannot change these read-only values.
After you enter the last parameter for side B, the following prompt appears at the
bottom of the screen:
Enter Admin Status (1 = Out of Service, 2 = In Service)
5 Set the administrative status of the circuit as desired.
The following prompt appears at the bottom of the screen.
Is above information correct? (y/n, [y]):
6 Enter
y
to confirm your configuration. A message confirming that the circuit has
been added appears at the bottom of the screen, as shown in Figure 153.
Figure 153 Completed Multicast Leaf Virtual Circuit
Virtual Circuit
Parameters
The following subsections describe the parameters you must enter when you
configure virtual circuits for different card types.
The parameters that you will actually see during configuration will depend on the
circuit type and the card type of your configuration. Also, some of the parameters
will appear on either side A or side B.