Chapter 45 Multicast
XGS2220 Series User’s Guide
307
The following table describes the labels in this screen.
45.13.2 MVR Configuration Example
The following figure shows a network example where ports 1, 2 and 3 on the Switch belong to VLAN 1. In
addition, port 7 belongs to the multicast group with VID 200 to receive multicast traffic (the
News
and
Movie
channels) from the remote streaming media server,
S
. Computers A, B and C in VLAN 1 are able
to receive the traffic.
Figure 223
MVR Configuration Example
To configure the MVR settings on the Switch, click the
Add/Edit
button in the
SWITCHING
>
Multicast
>
MVR
screen. Create a multicast VLAN and set the receiver and source ports.
Table 155 SWITCHING > Multicast > MVR > Group Setup > Add/Edit
LABEL
DESCRIPTION
Multicast VLAN ID
Select a multicast VLAN ID (that you configured in the
MVR
screen) from the drop-down list
box.
Group Name
Enter a descriptive name for identification purposes. You can enter up to 32 printable ASCII
characters except [ ? ], [ | ], [ ' ], [ " ] or [ , ].
Start Address
Enter the starting IP multicast address of the multicast group in dotted decimal notation.
End Address
Enter the ending IP multicast address of the multicast group in dotted decimal notation.
Enter the same IP address as the
Start Address
field if you want to configure only one IP
address for a multicast group.
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Save
link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Clear
Click
Clear
to clear the fields to the factory defaults.
Cancel
Click
Cancel
to not save the configuration you make and return to the last screen.