Chapter 45 Multicast
XGS2220 Series User’s Guide
302
Figure 217
SWITCHING > Multicast > IPv6 Multicast > Filtering Profile > Add Profile
The following table describes the fields in the above screen.
45.11.2 Add MLD Snooping-proxy Filtering Rule
Use this screen to create a multicast addresses range rule of the MLD filtering profile.
Click
Add Rule
in the
SWITCHING
>
Multicast
>
IPv6 Multicast
>
Filtering Profile
to display this screen.
Figure 218
SWITCHING > Multicast > IPv6 Multicast > Filtering Profile > Add Rule
Table 150 SWITCHING > Multicast > IPv6 Multicast > Filtering Profile > Add Profile
LABEL
DESCRIPTION
Profile Name
Enter a descriptive name (up to 32 printable ASCII characters except [?], [|], [‘], [“], [,]) for
the profile for identification purposes.
To configure additional rules for a profile that you have already added, enter the profile
name and specify a different IP multicast address range.
Start Address
Type the starting multicast IPv6 address for a range of multicast IPv6 addresses that you want
to belong to the MLD filtering profile.
End Address
Type the ending multicast IPv6 address for a range of IPv6 addresses that you want to
belong to the MLD filtering profile.
If you want to add a single multicast IPv6 address, enter it in both the
Start Address
and
End
Address
fields.
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Save
link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Clear
Click
Clear
to clear the fields to the factory defaults.
Cancel
Click
Cancel
to not save the configuration you make and return to the last screen.
