Chapter 45 Multicast
XGS2220 Series User’s Guide
305
45.13 MVR Group Setup
All source ports and receiver ports belonging to a multicast group can receive multicast data sent to this
multicast group.
Use this screen to view and configure MVR IP multicast group settings. Click
SWITCHING
>
Multicast
>
MVR
>
Group Setup
to access this screen.
Note: A port can belong to more than one multicast VLAN. However, IP multicast group
addresses in different multicast VLANs cannot overlap.
802.1p Priority
Select a priority level (0 – 7) with which the Switch replaces the priority in outgoing IGMP or
MLD control packets (belonging to this multicast VLAN).
Mode
Specify the MVR mode on the Switch. Choices are
Dynamic
and
Compatible
.
Select
Dynamic
to send IGMP reports or MLD messages to all MVR source ports in the multicast
VLAN.
Select
Compatible
to set the Switch not to send IGMP reports or MLD messages.
Use this section to configure MVR settings on each port.
Port
This field displays the port number on the Switch.
*
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to
set the common settings and then make adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
Source Port
Select this option to set this port as the MVR source port that sends and receives multicast
traffic. All source ports must belong to a single multicast VLAN.
Receiver Port
Select this option to set this port as a receiver port that only receives multicast traffic.
None
Select this option to set the port not to participate in MVR. No MVR multicast traffic is sent or
received on this port.
Tagging
Select this check box if you want the port to tag the VLAN ID in all outgoing frames
transmitted.
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Save
link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Clear
Click
Clear
to clear the fields to the factory defaults.
Cancel
Click
Cancel
to not save the configuration you make and return to the last screen.
Table 153 SWITCHING > Multicast > MVR > Add/Edit (continued)
LABEL
DESCRIPTION