Chapter 35 Link Layer Discovery Protocol (LLDP)
XGS2220 Series User’s Guide
247
Longitude
Enter the longitude information. The value should be from 0º to 180º.
• west
• east
Altitude
Enter the altitude information. The value should be from –2097151 to 2097151 in meters or in
floors.
• meters
• floor
Datum
Select the appropriate geodetic datum used by GPS.
• WGS84
• NAD83-NAVD88
• NAD83-MLLW
Civic Address
Enter the Civic Address by providing information such as Country, State, County, City, Street,
Number, ZIP code and other additional information. Enter at least 2 fields in this configuration
including the Country. The valid length of the Country field is 2 characters and all other fields
are up to 32 characters.
• Country
• State
• County
• City
• Division
• Neighbor
• Street
• Leading-Street-Direction
• Street-Suffix
• Trailing-Street-Suffix
• House-Number
• House-Number-Suffix
• Landmark
• Additional-Location
• Name
• Zip-Code
• Building
• Unit
• Floor
• Room-Number
• Place-Type
• Postal-Community-Name
• Post-Office-Box
• Additional-Code
ELIN Number
Enter a numerical digit string, corresponding to the ELIN identifier which is used during
emergency call setup to a traditional CAMA or ISDN trunk-based PSAP. The valid length is
from 10 to 25 characters.
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Save
link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Clear
Click
Clear
to clear the fields to the factory defaults.
Cancel
Click
Cancel
to not save the configuration you make and return to the last screen.
Table 120 PORT > LLDP > LLDP MED > LLDP-MED Location > Add/Edit (continued)
LABEL
DESCRIPTION
