Chapter 35 Link Layer Discovery Protocol (LLDP)
XGS2220 Series User’s Guide
241
35.7 Org-specific TLV Setting
Use this screen to configure organization-specific TLV settings. Click
PORT
>
LLDP
>
LLDP
>
Org-specific
TLV Setting
to display the screen as shown next.
Figure 172
PORT > LLDP > LLDP > Org-specific TLV Setting
The following table describes the labels in this screen.
System Capabilities
Select the check boxes to enable or to disable the sending of System Capabilities TLVs on the
ports.
System Description
Select the check boxes to enable or to disable the sending of System Description TLVs on the
ports.
System Name
Select the check boxes to enable or to disable the sending of System Name TLVs on the
ports.
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Save
link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel
Click
Cancel
to begin configuring this screen afresh.
Table 114 PORT > LLDP > LLDP > Basic TLV Setting (continued)
LABEL
DESCRIPTION
Table 115 PORT > LLDP > LLDP > Org-specific TLV Setting
LABEL
DESCRIPTION
Port
This displays the Switch’s port number.
*
Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
Dot1 TLV
