![background image](http://html1.mh-extra.com/html/xyz-machine-tools/trak-2op-m11-mill/trak-2op-m11-mill_safety-installation-maintenance-service-and-parts-list_3848763057.webp)
53
XYZ Machine Tools Ltd
TRAK
2
OP
Installation, Maintenance, Service & Part List Manual
that will show if the Overlay Key software running. If the Overlay
Key software is not running this may be a Compact Flash problem.
USB Device is not recognized by
the system.
Plug in the device to another port to see if the device is identify by a
different port, if it is not then the device may not be supported as
not all devices are compatible with this system.
Verify that the USB connector is not obstructed.
Plug USB device directly into the computer module USB port.
System Software does not respond
to any commands (Locks-up)
When the system does not respond to an Overlay command, verify
if the operating system is still operational by operating the system
from an external, USB keyboard.
Identify if the WDT LED is ON. If the LED is ON the system has
locked up.
System Will not boot up or error
on boot up
Try disconnecting all cables one at a time until only the 115 Power
Input, VGA, and Overlay Power cable are connected to the
computer module, if it still errors out then the computer module will
need replacing
Disk boot failure message
Make sure there is no USB device inserted to the computer module.
If problem continues refer to section 5.3 computer module
diagnostics.
Machine will not home
Verify the index pulse is being recognized by the computer module
by checking the LED’s described above.
5.4
Programming Panel
The programming panel attaches to the front of the machine via 4 screws and a gasket. The E-stop, EHW
and servo on button is part of this assembly. Please see figures 5.4a and 5.4b and drawing 28160.
In general, the Programmng Panel is best diagnosed by eliminating all other possible alternatives. The
following table lists some problems and what these problems can lead to. Make sure to first unplug any
accessories such as external keyboard/mouse USB thumb drives etc. to eliminate any interference.
Summary of Contents for TRAK 2OP M11 Mill
